Modify ↓
Ticket #2358 (closed defect: fixed)
Some bandwith graphs are not being shown when using multiple network interfaces
| Reported by: | cschultz@… | Owned by: | jalcubierre@… |
|---|---|---|---|
| Milestone: | 2.0.X | Component: | dashboard |
| Severity: | normal | Keywords: | |
| Cc: |
Description (last modified by jsoriano@…) (diff)
I was setting up a system on VMware ESXi 4.1 with 4 NICs. The fourth NIC on the dashboard will not display the bandwidth graphs. the other three are OK though. Haven't tried to relaod a second instance to see if it is a software bug or a bad install.
Attachments
Change History
comment:1 Changed 3 years ago by jsoriano@…
- Owner changed from jalcubierre@… to cperez@…
- Severity changed from minor to normal
- Summary changed from Minor issues with Zentyal 2.0.2 to Some bandwith graphs are not being shown when using multiple network interfaces
- Description modified (diff)
- Milestone set to 2.0.X
comment:2 Changed 3 years ago by cschultz@…
Reloaded the server over the weekend, and the 4th bandwidth graph is showing properly on this build. So maybe this was a bad initial build? Not sure.
Note: See
TracTickets for help on using
tickets.
Hi,
I have added the second issue to wishlist and removed it from description (each ticket should contain an only issue). The description was: In the DHCP server section, the references to the network adapters are using the system names (eth0, eth1, etc.) and not the friendly names assigned in Network:Interfaces. Did notice that any Virtual Interfaces assigned with static addresses show up partially correct (ie: eth0:gateway). Just a minor inconsistency, but since you seem to strive for ease of use for newbies, figured this would be a good recommendation.
Regards.